TO LISTEN, CLICK PLAY
Common Pool Leaks
Pool Light Leaks
Having a pool leak around light fixtures in the pool is common as the unit is typically bolted to the shell, creating a surface that will eventually grow a leak.
While this isn’t as dangerous as one would think, it’s still important to repair water coming into an electrical light source before it becomes a hazard.
If your pool light has recently shorted out or there is obviously water inside the glass container, you need a professional repair.
Pool return fittings, and even the return line, are a common source of leaks as they aid in directing the water back to the skimmer or the floor drain. The return fitting is a plastic addition which does wear out over time, and the return line can also develop small cracks with constant pressurized water flow.
If you begin seeing bubbles coming from the return area, chances are air is coming in from a small leak.
Leaks below the skimmer, or even developing a pool leak in skimmer, is common as it is the part of the pool tied directly into the filtration system. The added pressure and constant vibrations can develop small, to even large, cracks and leaks over time.
One of the most obvious telltale signs is needing to add water to your pool regularly or even daily. While it can be one of the more costly repairs, having pool leak under skimmer areas is not something that should be taken lightly.
Not only does it waste water and drive your monthly utility bill higher, it can easily cause your system to run dry and prematurely burn out.
Drain and Suction Leaks
Having a main drain or pool suction line leak is hard to tell as it’s at the bottom of your pool’s surface. It can also be hard to identify as it has the most amount of water.
If your skimmer is not making a gasping noise and you are seeing a large amount of air bubbles springing up from the bottom, chances are it’s a main drain or suction line leak.
Suction Line and Pressure Leaks
With above ground leak detection services, we can determine whether the leak is coming from inside the pool, or if you have a swimming pool suction leak inside the equipment area.
In your filtration system, a suction side pool leak may be a relatively easy fix; usually all it needs is a little more grease, or a new rubber ring which prevents air from being sucked in.
If it is a pressure side return leak, that may be a little trickier to fix. Pressure areas leaks are in the plumbing that leads back to the pool. One of the symptoms to look for is knowing whether you have a pool leak when pump is on, or a pool leak with pump off.
If the pump is off and your pool loses water, it’s probably in the pool itself; if you lose water with the pump on, it’s probably in the filtration system.
If you do find that it’s a leak when the pump is on, one of the most obvious signs to look for is water trickling, dripping, or even spraying from the PVC tubing or from the system pump itself.
It may actually require a little bit of inspection work, as small leaks can be silent and can happen from inconvenient spots, such as from the side of the tubes that face the ground.
You can always carefully run your hand over the plastic surfaces and check for moisture. Also, if you happen to hear any “gasping” or “sucking” sounds near the system or tubing, it’s probably drawing in air.
When you need pool leak detection and repair in Canoga Park, Woodland Hills, Sherman Oaks, Calabasas, Northridge and all other communities surrounding Thousand Oaks, give Pool Leak Detection Services in Thousand Oaks a call.
Helpful Resources For Your Swimming Pool
- 5 Tips Of Pool Leak Detection
- 10 Signs You Have A Water Main Leak
- How To Remove Pool Algae
- How To Fix Cloudy Pool Water
- Understanding Pool Cartridge Filters
- Understanding Pool Chlorine
- Common Pool Leaks
- Pros & Cons Of Hiring Leak Detector
- Pool Leaking Vs Water Evaporating
- Low Water Pressure
- Signs Of A Gas Leak
- Detect An Irrigation Leak
- Warning Signs Of A Slab Leak
- Pool Skimmer Leaks